Thursday, June 2, 2011

Anyone know how to loosen the serpentine belt on a taurus wagon?

I just bought an older (1999) ford taurus wagon and need to change the alternator. Where do they hide the bolts to adjust the tension of the idler? And are there any simple tricks to removing or replacing these alternators?

Thanks a bunch.Anyone know how to loosen the serpentine belt on a taurus wagon?
you need a special tool if you go to just about any auto parts store you can buy a kit it comes with all the sockets and handles that you will need you might not use it alot but you will be glad you have it when you need it....... all the other ideas could work but it is so close to the strut tower just by the kit it will save you money in band-aidsAnyone know how to loosen the serpentine belt on a taurus wagon?
stick a 3/8 ratchet in the hole and move it to make it looser. you can't adjust the tension. They are set, you just rotate it with a ratchet.Anyone know how to loosen the serpentine belt on a taurus wagon?
it takes a special wrench but you should be able to push it in the direction to loosen it with your hand spring loaded try that.Anyone know how to loosen the serpentine belt on a taurus wagon?
in the middle of your tension-er there is a bolt get a wrench.and simply turn the bolt and that will give you play to remove your belt .there is no way to adjust that spring loaded tension-er pulley..if its bad replace it..good luckAnyone know how to loosen the serpentine belt on a taurus wagon?
the hole doug w. is talking about is in the belt tensioner,it may be 1/2 instead of 3/8 i just helped my son change a belt on his 95 couger %26amp; it was 1/2.just put the breaker bar or ratchet in the square hole in the tensioner %26amp; rotate clockwise to loosen the preload off of the tensioner %26amp; the belt comes right off!Anyone know how to loosen the serpentine belt on a taurus wagon?
there are two types of tensioner adjusters.one type has a squre hole cut out in it so you can insert a rachet or breaker bar into it and either push or pull to release tension.the other type has a hex head bolt on it usually a 14mm socket on a rachet will dp the trick and again you either push or pullAnyone know how to loosen the serpentine belt on a taurus wagon?
The tensioner is spring loaded,use a break bar or ratchet to pull the tensioner in and release the belt. This is a square hole the size of the ratchet